Well I did reinstall the new igniter.
For anyone who has to do it:
1-Remove the 10 screws on the end of the pellet storage
2-Follow the two white wires. Remove the fan on the bottom to gain access through the round hole on the bottom towards where the fire chamber is
3-With a flashlight and some positioning, you can see where the ignitor is secured by two screws
4-Carefully remove the philips head screws
5-Remove the old igniter. Take the two screws that you removed and thread them into the holes on the end of the new igniter.
6-Hold the screws in place with two pieces of cardboard
7-Replace the assembly in the firepot and tighten the screws in place
8-Replace fan screws, push ends of igniter wires into plug and plug into female plug end.
9-Secure slack and replace screws on end assembly and you are good to go!
Works like a charm