Skip to main content

Replies sorted oldest to newest

These smokers can generate a fair amount of condensation inside from the meat as it smokes in addition to the moisture from the wood itself. Normally, this is not a problem.  If your GFCI outlets are overly sensitive, they will trip. Also, and not common, is an mis-wired outlet. Have you connected up another high amp heat generating appliance to the same outlet? Does it trip? How many appliances are on the electrical circuit your smoker is connected to? Are you using an extension cord? and is it in good shape and of same wire gauge of better as the smoker cord?  I would look for earth leakage if all else is well.

https://https://www.fluke.com/en-us/learn/blog/clamps/leakage-current-measurement-basics/en-us/learn/blog/clamps/leakage-current-measurement-basics

Also, there could be residual moisture around the element that just sits there between smokes. I suggest, as part of cleaning up, that you wipe down the element where it inters the cabinet and air it out after it cools.  Over on another forum I am with, some folks have advised to use a hair dryer on the element because of a similar problem before powering up the smoker and it has apparently solved the issue.  I may have mentioned that trick on an earlier post. Good luck.

EDIT: https://www.marinadockage.com/...-ac-leakage-current/

Last edited by oldsarge

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×