I've had my cookshack for a little less than two years. The probe didn't work when I got it, a year down the road, the door cutoff switch went out, and today, a week before a big event, my smoker just died. Question....if the heating element goes out, will it cut off juice to the display? I powered it up today, and just as it started to warm, the display began to dim, flicker, then slowly fade out. Could it be that the element crapped out, or could it be the control module? It did not continue to warm.
Original Post
I'd say CS service could qick talk you thru a check on the sensor-simple-or the controller.Realize it is the weekend,but they would be the best bet.

What kind of reply is that? I can see this was a waste of my time come no here! 

Resurrecting an ancient thread is considered bad etiquette, not just on this forum, but on any forum.  Start a new thread please.

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×