FEC 100 getting to temp

I recently went thru a similar problem with my F100 (2 yrs old). CS sent me a new auger, then a new board...no improvement. I was running 30 - 40 degrees under set temp. They then sent me a new auger motor and that seems to have fixed the problem.

My suggestion would be to empty the hopper and vacuum out both ends of the auger. Detach the auger from the motor snd check for warn edges and pitting. If that doesn't help you may need a motor replacement. Talk to Bill or Tony in customer service.

You can try increasing the temp by the amount you're falling short in the meantime.

I can't say enough for Cookshack's customer service. They replaced a small fortune in free parts trying to get me back on track. The board and motor were replaced AFTER the end of my 2 year warranty/ Try and match that anywhere else.

Good luck.

Thanks for the reply! I will give this a shot. Appreciate the quick response.

Sounds like there could be pellet dust built up in your hopper.