FEC240 Over Temp Error after new board install

babakevinMember

Bill sent me a new IQ5 power supply and FEC Varistor. I've installed both according to instructions, updated firmware to 224-M.

The unit powers up, but the Over Temp Error appears after pressing start. I've pushed the green button on the back of the unit, even held it down, but the error doesn't clear and I can't use the smoker.

Suggestions? Is there an Over Temp by-pass or other switch on the mother boards to clear this error?

9/3/194:02 AM

❤️ 0

Original Post

electrotechMember

If you are getting an over temp error at start up it is generally caused from a connection issue with the thermocouple I would check and make sure your yellow wire is in the yellow position and red is in red. Make sure the connection is snug. If it give you anymore problems call our tech support.

9/3/199:44 AM

❤️ 0

Add Reply

<ul id="{%=id%}ButtonGroup" class="button-group h-popup-buttons even-button-group even-1">
    <li id="{%=id%}Okay_buttonContainer"><a id="{%=id%}Okay" href="javascript:void(0);" class="button success no-margin-bottom h-alert-modal-ok-button" role="button">OK</a><script type="text/javascript">
        (function() {
            function {%=id%}Okay_click(event, data) {
            {%=id%}Popup.hide();
        }
        
                $('#{%=id%}Okay').on('click', {%=id%}Okay_click);
        })();
    </script></li></ul><a href="javascript:void(0);" class="close-reveal-modal" aria-label="Close Modal">&#215;</a><div class="last-modal-focus focus-utility-element" tabindex="0"></div>
</div>
<script type="text/javascript">
        (function() {
            {%=id%}Popup = new SS.Popup.ModalPopup('{%=id%}');
        })();
    </script>

Skip to main content

Add Reply

Membership Required

Remove From Your Block List

Manage Follow Preferences

Block

Please wait...