So when I first got my 240 I was not properly cleaning the ash which resulted in igniter failure but since then I have been cleaning it vacuuming it and taking care of the ash cup properly and I believe my igniter went out again? Pellets are dropping in but no fire anyone have any ideas or suggestions?
Replies sorted oldest to newest
I would get with tech support on this. In the meantime, here's a wiring diagram and maybe it is nothing more than a loose wire or something.
There is a fuse, F1 on the relay board in the control box. I’ve had it blow once after the igniter - replacement did not work which led to the fuse. Per tech support notes,” it seems to happen about 10% of the time when igniter goes. & The fuse is a 5 X 20 MM 10A 250V slow blow fuse” . I found some on Amazon. Cookshack carries them as well and other electrical supply types.
