Skip to main content

Just a couple of tips from a newbie who just finished setting up a SM008 and a stand.

1. They have changed the design on the base of the stand so it does not match the included instructions. The casters bolt into the bottom rail of the stand and the casters with the lock/unlock lever go in the front two holes.

2. Bolting the stand to the unit is difficult because there are no instructions or markers on the top of the stand. (Oh for an alignment mark on the top of the stand.) For the forward 2 bolts that go through the roof of the stand use the elliptical holes not the round holes. It is MUCH easier if you flatten the shipping boxes and use them as a flat on the ground workspace. If you put both the unit and the stand on their backs you can see the holes in the bottom of the Smokette and get the bolts in where they belong.

3. There will be parts left over. Customer Service says there are numerous extra parts sent just in case (I have an extra pair of casters and several tiny nuts and washers.)

I hope this saves someone some frustration and saves calls to the friendly folks at Customer Service
Last edited {1}
Original Post

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×