Hopper lid hold down

You could get self stick plastic refrigerator locks. They are in the childproof safety section of Lowes etc. No drilling, very effective.

How about a couple of bricks?

Maybe I'm missing something, but isn't the answer just to use a couple of bungees to keep your cover from blowing off?

quote:

Maybe I'm missing something, but isn't the answer just to use a couple of bungees to keep your cover from blowing off?

Or even to hold down the lid....

quote:

Originally posted by Pags:
How about a couple of bricks?

Pag’s, I was thinking a beer cooler, but your idea would be more convenient.

Hope all is well.

T

I bought 2 latches from Cookshack like they install on their FEC100's. Yes there was some drilling of the stainless to get the latches on and then the slots for the latches to hook into. The stainless steel they use for the PG500 is relatively easy to drill - just use low speed and lots of pressure.
Warning, Cookshack is rather proud on their latches, $$$$. Although one latch would be enough to secure the lid, I used 2 latches so I would not mess-up the nameplate decal they installed at middle of the hopper. (Sorry but I am too technically challenged to attach any pics of what I did.)
I'm sure you can find a similar latch from another supplier. I think Cookshack's are stainless which I wanted.

One thing I have noticed is I sometimes get a little condensation on bottom of hopper lid with it closed-up tight when weather conditions are right for it up here in the Pacific Northwet and the PG500 is running for more than an hour or so. Easy to open lid and wipe any condensation up with a paper towel.

Thank you for all the tips. I like the idea of a latch. I also thought about a single Dzus fastener as well.

Mr. T-

Your idea is much more practical.

Plus you'd have a modified outdoor kitchen.

Cookshack customer support comes through as always. They recommended this latch.